Wide Angle Diffusion Head; M-Slave Mode - Leica SF 64 Mode D'emploi

EN WIDE-ANGLE DIFFUSER HEAD
With the integrated wide-angle diffuser head
lengths from 12mm can be illuminated.
Procedure:
Pull the wide-angle diffuser head out of the reflector
forwards as far as it will go and let go
The wide-angle diffuser head automatically folds
down. The reflector is automatically set to the
required position.
• The distance information and the zoom value are
The motor zoom reflector is not automatically
adjusted when the wide-angle diffuser head is used.
1. To push in, fold the wide-angle diffuser head up
70
corrected to 12mm on the display.
by 90° and push in completely
focal
6 c

M-SLAVE MODE

In this mode, the flash unit can be used as a second
source of light remotely from the camera without any
cables. For this, it is triggered by the main flash of the
(lead) flash unit on the camera.
In mode, only manual flash operation is
M-SLAVE
generally possible. It is set automatically after the
mode has been switched on.
M-SLAVE
Setting the operating mode:
1. Make the necessary settings for flash operation
on the camera
2. Press the sensor button for the displayed mode
repeatedly until the relevant selection list appears
3. Use / to move to the central field
▲ ▼
M-SLAVE
outlined in red
4. Press
M-SLAVE
The mode is accepted immediately.
• When the flash is ready, the AF measuring flash
flashes.
If desired, a partial light output (see p. 65) can be set.