2Remote Access Through An Alarm Message; Functions In Remote Access Mode - Abus AZWG10020 Instructions D'installation Et De Service

1. Dial into the device by entering the telephone number of the de-
vice.
2. Let it ring once or twice and then hang up.
3. Wait about 10 seconds and then dial into the device again. The
device now accepts the call immediately after the first ring. You
will hear several beeps.
4. Now enter your 4-digit remote access code (factory setting: 5678).
A confirmation signal sounds if the entered code is correct. You
are now in remote access mode. The options that are now possi-
ble are described later in the Functions section.
13.4.2 Remote access through an alarm message
With this option, you take action after an alarm call from the device.
In this case, the called contact can start remote access mode after confirma-
tion of the message.
"Remote Access" must be turned ON. See "Menu Functions 
System Options  Remote Options".
Message confirmation and start of remote access mode
1. Answer the telephone as normal when it rings.
2. Listen to the message. The message is repeated several times.
3. If you have understood the message, you have two options:

Press the 8 key on your telephone. The message is con-
firmed as usual, and the call ends.

Press the star key (*) on your telephone. This confirms the
message, and remote access can be started.
4. You will hear several beeps.
5. Now enter your 4-digit remote access code (factory setting: 5678).
A confirmation signal sounds if the entered code is correct. You
are now in remote access mode. The options that are now possi-
ble are described later in the Functions section.
13.4.3

Functions in remote access mode

If 60 seconds pass without a command being sent, the device
terminates the telephone connection automatically.
Caution!
After a command is sent, the device maintains the telephone
connection for 5 minutes.
Pressing the pound key (#) on the telephone ends remote
access.
The following functions can be performed in remote access mode. To enter
commands, you use the number keys on your telephone keypad.
Function
Switch outputs 1–4
Telephone key sequence and notes
*11
Switch output of type
42 UK