Abus AZWG10020 Instructions D'installation Et De Service page 90

Call Name 01
Ack Name 01
User Abort
Sys Restart
Temp H Alarm
Temp H Clear
Temp L Alarm
Temp L Clear
Phone Line
Fault
Line OK
Remote Start
Remote Clear
Time changed
Supply Low
Supply OK
Auto Report
Log Cleared
No Ack Name
Inputs B–H analogously
Call to contact 1
Contacts 2-10 analogously
The contact name is displayed as programmed.
"Name 01" is the factory setting.
Acknowledgment of the message by contact 1
Contacts 2-10 analogously
The contact name is displayed as programmed.
"Name 01" is the factory setting.
Message is aborted using passcode
System start of device. The device was switched on.
The temperature has exceeded the preset upper tempera-
ture limit
The temperature has fallen below the preset upper tem-
perature limit again
The temperature has fallen below the preset lower temper-
ature limit
The temperature has exceeded the preset lower tempera-
ture limit again
Telephone line not available for more than 40 s
For the device, the telephone line is available
when the voltage on the a/b line > 3 V.
Telephone line back in normal state
Remote access established
Remote access ended
System date and system time have been changed
The supply voltage has fallen below the preset lower volt-
age limit
The supply voltage has again exceeded the preset lower
voltage limit. The supply voltage is again in the normal
range.
Automatic test call
Event log was deleted
After a complete factory reset, the event log is
deleted.
No acknowledgment of the message by contact 1
35 UK