Antenna Connection; Pstn Module - Abus AZWG10020 Instructions D'installation Et De Service

9.2.2

Antenna connection

Connect the connector of the antenna cable to the antenna socket.
Use the supplied alcohol-soaked cloth to clean and de-grease the area on
which you intend to install the antenna.
Remove the protective foil on the adhesive side of the antenna. Adhere the
antenna to the cleaned surface.
The adhesive on the antenna bonds immediately. You cannot cor-
rect the position once the antenna is fixed in place.
9.2.3

PSTN module

The PSTN module is a plug-in board for the device. It allows connection to a
wired telephone network.
The PSTN module is connected to the mainboard at the factory.
!
Caution
Remove the PSTN module from the mainboard.
Place the plastic spacer as indicated in the picture. It is usually preassem-
bled, however.
Remove the protective foil of the tape strip only after all wiring and
testing is complete.
Disconnect the device from the power before you re-
move (detach) the PSTN module and reattach it.
13 UK