Test Functions; Message Test; Auto Report - Abus Terxon PSTN Instructions D'installation

10.11 Test functions

10.11.1 Message test

1. Enter your programming code (default: 1234). The following
message is shown in the display:
Press -
example shows message A:
Press the key again for the corresponding message (key A in this
example).
After a few seconds, the identification message (phrase 0) and the
alarm message are played for the key that was previously selected.
Data entry can be finished by pressing
been played.

10.11.2 Auto report

1. Enter your programming code (default: 1234). The following
message is shown in the display:
Press -
example shows message A:
depending on which message you wish to play. This
depending on which message you wish to send. This
READY
SEND A
ON 1-4
PHRASE 0
PHRASE A
after the message has
READY
SEND A
ON 1-4
59