Abort - Abus Terxon PSTN Instructions D'installation

1. Enter your programming code (default: 1234). The following
message is shown in the display:
Press . The display shows the following:
Press to display the current allocation of telephone numbers to
alarm message A. In this example, the alarm message A is transferred
to telephone numbers 1 and 3.
Telephone numbers can be added or removed using the
keys.
Press the
steps 3 and 4 for the remaining messages.
When the voice message has been allocated to the telephone number,
confirm by pressing
Press to end data entry.

10.8 Abort

If an alarm is triggered by accident and the dialer starts an alarm call,
then this can be aborted in a variety of ways. This function is used to
define which abort types are possible:
-
-
-
key to switch to the other voice messages (B-D). Repeat
.
INPUT: Creation of a signal on the "ABORT TRIG"
input.
RESTORE: Removal of the trigger signal on the
input.
PASSCODE: Entry of the programming code.
READY
ROUTE-
A> 1-3-
C> ---4
READY
55
-