Ack (Acknowledge) - Abus Terxon PSTN Instructions D'installation

10.10 Ack (acknowledge)

If the Terxon PSTN dialer has played the voice message to the
recipient, then the device requires an acknowledgement that the
message has been transmitted successfully. This is made by pressing
the 8 key on the telephone. Message transmission is ended when the
message receipt is confirmed.
The settings in this menu define how often the message must be
confirmed before transmission is deemed successful. The following
options are available:
-
-
-
-
-
Enter your programming code (default: 1234). The following message
is shown in the display:
Press . The display shows the following:
Press to display the current selection.
Press the
Confirm your selection with
Press to end data entry.
ANY-1: One confirmation signal necessary.
ANY-2: Two confirmation signals necessary.
ANY-3: Three confirmation signals necessary.
ANY-4: Four confirmation signals necessary.
NO-ONE: No confirmation signal necessary.
key to switch between options.
READY
CLRBY-
ANY-1
.
ANY-2
58