Hardware Reset; Accessing The Programming Menu; Starting The Programming Menu - Abus Terxon PSTN Instructions D'installation

9.1.2

Hardware reset

1. Disconnect the power supply from the Terxon PSTN dialer.
Bypass the "Factory Default" jumper on the mainboard using a small
screwdriver or similar tool.
Connect the power supply to the device.
Remove the screwdriver and reattach the housing cover. Make sure
that you do not trap or restrict any cables. The Terxon PSTN dialer
now beeps every 30 seconds and displays the following:
To access the programming menu, enter your programming code
(default: 1234). The display shows the following:
Start the programming of the device.
9.2

Accessing the programming menu

9.2.1

Starting the programming menu

1. The following message is displayed when the Terxon PSTN
dialer is put into operation for the first time:
PLEASE
RECORD
READY
PLEASE
RECORD
46