Connecting The Appliance - Gaggenau AC270101 Notice D'utilisation Et De Montage

en Installation instructions
Move the frame so that the screws lock into place in
3.
the key hole openings and can be screwed in
tightly.
13
Align the frame and use two screws to secure it in
4.
place.
Place a scissor lift table or another suitable device
5.
under the appliance.
Do not place the scissor lift table on the hob.
Position the appliance on the scissor lift table so
6.
that the appliance is on the frame.
Do not place the appliance on the grease filters as
these could be damaged.
Leave a gap of at least 700 mm between the hob
7.
and the lower edge of the appliance.
When securing cables, ensure that the maximum
distance between the frame cover and the top edge
of the appliance is 1.20 m.

Connecting the appliance

Pull the protective tube over the on-site cable.
1.
Shorten the protective tube if necessary.
40
Insert the on-site cable into the terminal plug.
2.
Thread the four cables into the lock nuts.
3.
Do not insert the lock nuts into the openings to
avoid damaging the appliance's limit switch.
To protect against scratches, position a spacer on
4.
the appliance and place the frame cover on top of
it.