Operating Modes; Exhaust Air Mode; Air Recirculation; Getting To Know The Appliance - Gaggenau AL400 Notice D'utilisation

Operating modes

This appliance can be used in exhaust-air mode or
circulating-air mode.

Exhaust air mode

The air which is drawn in is cleaned by the
grease filters and conveyed to the exterior
by a pipe system.
Note: The exhaust air must not be conveyed into a
functioning smoke or exhaust gas flue or into a shaft
which is used to ventilate installation rooms which
contain heating appliances.
▯
Before conveying the exhaust air into a non-
functioning smoke or exhaust gas flue, obtain the
consent of the heating engineer responsible.
▯
If the exhaust air is conveyed through the outer
wall, a telescopic wall box should be used.

Air recirculation

The air which is drawn in is cleaned by
the grease filters and an activated carbon
filter, and is conveyed back into the
kitchen.
Note: To bind odours in air recirculation mode, you
must install an activated carbon filter. The different
options for operating the appliance in air recirculation
mode can be found in the brochure. Alternatively, ask
your dealer. The required accessories are available
from specialist retailers, from customer service or
from the Online Shop.
18

Getting to know the appliance

Here, you can get to know your appliance and receive
information about the accessories.
1 Switch for retracting/extending
2 Lighting
3

Control panel

4 Filter cover
Control panel
All function selection buttons are lit when they are
active. The "saturation indicator" control light flashes.
@
Light on/off
œ
Saturation indicator
ž
Run-on function
Ž
Intensive setting
3 Fan speed 3
2 Fan speed 2
1 Fan speed 1
ÿ
Fan on/off