Causes Of Damage; Protecting The Environment; Operating Modes; Air Extraction - Gaggenau VL 200 120 Notice D'utilisation

Causes of damage

C a u s e s o f d a m a g e
R isk of damage due to ingress of humidity into the
electronic circuitry. Never clean operator controls with a
wet cloth.
Surface damage due to strong or abrasive cleaning
agents. Never use strong and abrasive cleaning agents.

Protecting the environment

Unpack the appliance and dispose of the packaging in an
environmentally friendly manner.

Operating modes

O p e r a t i n g m o d e s
T his appliance can be used in air extraction or air
recirculation mode depending on the remote fan unit
connected.

Air extraction

The air sucked in is cleaned by the
grease filters and is routed outdoors
through a pipe system.
Note: The extracted air must neither be discharged into
an operating smoke or waste gas chimney nor into a shaft
that serves to ventilate rooms where heat-producing
appliances are installed.
The local chimney sweep's consent must be obtained
▯
if the exhaust air is to be routed to a smoke or waste
gas chimney that is not in operation.
A telescopic wall duct should be used if the exhaust
▯
air is routed through the outside wall.

Recirculation

The aspirated air is cleaned by the grease
filters and an activated charcoal filter and
is returned to the kitchen.
Note: You must install an activated charcoal filter to bind
odors in the recirculation mode. Refer to the manual or
ask your specialist dealer for details of the various
options for operating the appliance in the recirculation
mode. You can obtain the necessary accessories from
specialist dealers, from our after-sales service or in the
online shop.
en-us
Causes of damage
11