Removing And Refitting The Metal Grease Filter - Gaggenau AL400 Notice D'utilisation

Removing and refitting the metal
grease filter
Opening the filter cover
1 Take hold of the filter cover and pull it upwards.
2 Fold the filter cover forwards.
Removing metal grease filter
1 Open the lock and fold the metal grease filter
forwards.
2 Take the metal grease filter out of the holder.
Notes
‒ Grease can accumulate in the bottom of the
metal grease filter.
‒ Hold the metal grease filter level, otherwise
grease will drip out.
3 Clean the metal grease filter.
22
Cleaning the grease drain channels
To facilitate cleaning, you can remove the grease drain
channels. You can clean the grease drain channels in
the dishwasher.
1 Remove the grease drain channels.
2 Clean the grease drain channels.
3 Re-insert the grease drain channels.
Installing the metal mesh grease filter
1 Insert the metal grease filter.
2 Fold the metal grease filter to the rear, locking it
in place.
3 Reset the saturation indicators by pressing the
button.
The saturation indicator
Closing the filter cover
Take hold of the filter cover and fold it closed.
The filter cover snaps into place.
Cleaning the filter cover
To facilitate cleaning, you can remove the filter cover.
1 Open the filter cover.
2 Take hold of the side of the filter cover with both
hands.
3 Lift the rear section as far as it will go and pull the
filter cover forwards.
The filter cover can be pulled over the bolts of the
holder.
4 Clean the filter cover.
œ
œ
goes out.