Removing And Installing The Metal Grease Filter - Gaggenau VL 414 110 Notice D'utilisation

By hand:
Note: You can use a special grease solvent if soiling
is stubborn. You can order it via the online shop.
▯
Soak the metal grease filters in hot soapy
solution.
▯
Use a brush for cleaning and then rinse the filters
well.
▯
Allow the metal grease filters to drip dry.
Removing and installing the metal
grease filter
Removing the metal grease filter
1 Move the sealing element to the middle position
and pull it out in the upward direction. The sealing
element snaps out of its holder.
Notes
‒ Use a kitchen towel to remove the sealing
element.
‒ The sealing element can get scratched while
lifting it out and putting it down! Lift out the
sealing element straight in the upward
direction and do not tilt it.
2 Turn up both holding wires. At the bottom, press
together the holding wires slightly so that the
metal grease filter comes out of the arrester. Pull
the metal grease filter out of the appliance in the
upward direction.
3 Clean the metal grease filter.
4 Clean the interior of the appliance.
14
Installing the metal grease filter
1 Press down the metal grease filter until it
engages on the side arresters.
2 Turn down both holding wires.
3 Press down the sealing element in the middle
position until it engages with an audible click on
the two holders at the sides.
"
Note: The symbol on the sealing element must
be at the front.