Special Accessories; Installation Accessories; Operation; Before First Use - Gaggenau VL 414 110 Notice D'utilisation

Special accessories

You can order the following accessories from your
specialist dealer:
AA 414 010 Ventilation molding, for operation next
to the VG 414/415/424/425 gas
appliance
Use the accessories only as indicated. The
manufacturer assumes no liability for incorrect usage
of the accessories.

Installation accessories

VA 420 000 Connection strip for combination
with other Vario appliances in the
400 series for flush installation
VA 420 001 Connection strip for combination
with other Vario appliances in the
400 series for flush installation with
appliance cover/compensation strip
VA 420 010 Connection strip for combination
with other Vario appliances in the
400 series for surface-mounted
installation
VA 420 011 Connection strip for combination
with other Vario appliances in the
400 series for surface-mounted
installation with appliance cover/
compensation strip
VA 450 110 11 cm compensation strip for depth
compensation when using several
Vario appliances
AD 724 040 Connection piece for round duct
system DN 125 mm. For lateral
connection to VL 414 the additional
adaptor AD 724 041 is required.
AD 724 041 Connection piece for round duct
system NW 125 mm. Required for
lateral connection to VL 414.
AS 070 000 Connection piece for extension for
installation next to VK or VF

Operation

Before first use

Bear in mind the following instructions before using
the appliance for the first time:
Thoroughly clean the appliance and accessories.

Turning on

Three ventilation levels and one intensive level
available for extraction.
1 Open the sealing elements.
Note: At least one sealing element must be open
as otherwise the fan will not switch on.
2 Press in the temperature control knob and turn it
to the right to the desired fan speed.
The illuminated ring behind the knob flashes.
Intensive level
The intensive level runs for ten minutes. After expiry of
this time, ventilation is automatically switched back to
fan level 3. The illuminated ring behind the control
knob flashes as long as the control knob is still set to
the intensive level position
intensive level and at least one ventilation element is
open.

Turning off

1 Turn the control knob to the 0 position.
2 Close the sealing elements.
Ž
are
Ž
after expiry of the
11