Gaggenau AC270101 Notice D'utilisation Et De Montage page 41

Thread the cables through the openings of the
5.
frame cover.
Undo the strain relief on the cable on the appliance
6.
and pull out the cable.
Remove the strain relief fitted at the factory.
7.
Put the strain relief to one side.
ATTENTION! There is a risk of damage to the appli-
8.
ance if the cable is coiled up.
Always secure the cable firmly using the strain
▶
relief so that it does not coil up fully in the appli-
ance.
Thread the cable on the appliance through the
opening in the frame cover and use the strain relief
supplied to secure it.
Thread the four cables into the cable tensioner and
9.
apply equal tension.
Do not shorten the cables.
Readjust the cables. To do this, relieve the load on
10.
the appliance, loosen the cable tensioner and push
the cables up.
Thread the four enclosed cable clamps and secure
11.
in place approx. 20 mm in front of the cable ten-
sioner.
2
Tighten the screws by hand.
Installation instructions en
20 mm
41