Troubleshooting - Gaggenau AC270101 Notice D'utilisation Et De Montage

Insert the new batteries (3 V CR 2032).
3.
Close the cover.
4.
Dispose of the empty batteries in an environmentally
5.
friendly manner.
Malfunctions
Fault
The appliance is not working.
The lighting does not work.
Remote control not working.
In the LED display, the LEDs
flash one to five times after the
appliance is switched off.
The lighting automatically
switches on as soon as the appli-
ance is connected to the power
supply.
LED 1 flashes in the LED display. The grease filters are saturated.
LED 2 flashes in the LED display. The odour filters are saturated.
Once the appliance has been
connected to the power supply,
the lighting switches on automat-
ically.
Unusual noises when the appli-
ance moves up or down.
A signal tone sounds three times. The reference movement was not
Cause
The mains plug of the power
cord is not plugged in.
Different causes are possible.
The batteries are flat.
The batteries are almost empty.
Demo mode is switched on.
Demo mode is activated.
Cables may be damaged.
carried out.

Troubleshooting

You can rectify minor faults on your appliance yourself.
Read the troubleshooting information before contacting
after-sales service. This will avoid unnecessary costs.
WARNING ‒ Risk of injury!
Improper repairs are dangerous.
Repairs to the appliance should only be carried out
▶
by trained specialist staff.
If the appliance is defective, call Customer Service.
▶
WARNING ‒ Risk of electric shock!
Improper repairs are dangerous.
Repairs to the appliance should only be carried out
▶
by trained specialist staff.
Only use genuine spare parts when repairing the
▶
appliance.
If the power cord of this appliance is damaged, it
▶
must be replaced by trained specialist staff.
troubleshooting
Connect the appliance to the power sup-
▶
ply.
Call the after-sales service.
▶
→ "Customer Service", Page 36
Defective LED lights may be replaced by
▶
the manufacturer, their customer service
or a qualified technician (electrician) only.
→ "Replacing the batteries in the remote
▶
control", Page 34
→ "Replacing the batteries in the remote
▶
control", Page 34
Press and hold ⁠ and ⁠ for approx. three
▶
seconds.
→ "Cleaning grease filters in the dish-
▶
washer", Page 33
→ "Cleaning grease filters manually",
▶
Page 33
Change the odour filter. → Page 34
▶
To deactivate demo mode, press and
▶
hold ⁠ and ⁠
Call the after-sales service.
▶
→ "Customer Service", Page 36
Start the reference movement with ⁠
▶
and ⁠ .
Troubleshooting en
for approx. for 3 seconds.
35