Troubleshooting; Fault Table - Gaggenau AI 442 720 Notice D'utilisation

Troubleshooting

You can often easily eliminate problems that may
occur on your own. Before calling customer service,
take into account the following information.
9
WARNING
Risk of electric shock
Improper repairs are dangerous. Only an after-
sales technician trained by us may perform
repairs and may replace damaged connecting
leads. Remove the mains plug or deactivate the
fuse in the fuse box if the appliance is defective.
Call after-sales service.

Fault table

Disruption
The appliance does not work
The appliance does not work, all buttons
flash
The appliance does not work
The button illumination does not work
The lighting does not work
œ
The button flashes
--------
9
LED lights
Defective LED lights may be replaced by the
manufacturer, his customer service or a qualified
technician (electrician) only.
Possible cause
The plug is not plugged in
Power failure
The fuse is faulty
The network cable plug is not plugged
in
The fuse is faulty
A component of the appliance has failed Call Customer Service
The appliance has been operating for
longer than 4 hours, safety shut-off was
activated
The control unit is faulty
The lighting is defective
The metal filter is saturated
WARNING
Risk of injury
The light emitted by LED lights is very dazzling,
and can damage the eyes (risk group 1). Do not
look directly into the switched on LED lights for
longer than 100 seconds.
Solution
Connect the appliance to the electricity
supply
Check whether other kitchen appliances
are working
Check in the fuse box to make sure that
the fuse for the appliance is in working
order
Check network cable connection for all
appliances
Check in the fuse box to make sure that
the fuses for all appliances are in work-
ing order
Switch the appliance on again
Call Customer Service
Call Customer Service
Clean the filter, see the
maintenance
section
Cleaning and
15