Télécharger Imprimer la page

DeWalt DPC6MRC-QS Manuel D'instructions Et D'utilisation page 15

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
CODE
POSSIBLE CAUSE
10
Hole in air hose
11
Check valve restricted
12
Air leaks
13
Regulator is damaged
Unit operating in damp or humid
14
conditions
15
Restricted air intake filter
16
Engine or pump oil is low
17
Carbon build-up in pump.
18
Detergent type oil being used in pump
Motor overload protection switch has
19
tripped
20
Extension cord is wrong length or gauge
21
Loose electrical connections
Possible defective motor or starting
22
capacitor
23
Paint spray on internal motor parts
24
Fuse blown, circuit breaker tripped
Tank pressure exceeds pressure switch
25
cut-in pressure
Pressure release valve on pressure switch
26
has not unloaded head pressure
All manuals and user guides at all-guides.com
POSSIBLE SOLUTION
Replace air hose.
Remove, clean or replace.
Tighten fittings.
Replace.
Move unit to a dry well ventilated area
Clean or replace air intake filter
Add same type of oil in crankcase to pump. See Compressor Pump
Oil under Maintenance.
Contact a D
service center.
Drain oil and refill pump using D
40, non-detergent air compressor oil.
See Motor Overload under Features.
Check for proper gauge wire and cord length. See Extension
Cords under Installation.
Contact a D
service center.
Contact a D
service center.
Contact a D
service center. Do not operate the compressor in the paint spray
area. See flammable vapor warning.
1. Check fuse box for blown fuse and replace as necessary.
Reset circuit breaker. Do not use a fuse or circuit breaker
with higher rating than that specified for your particular
branch circuit.
2. Check for proper fuse. Use only a time delay fuse.
3. Check for low voltage conditions and/or proper extension
cord.
4. Disconnect the other electrical appliances from circuit or
operate the compressor on its own branch circuit.
Motor will start automatically when tank pressure drops below
cut-in pressure of pressure switch.
Set the On/Off switch to OFF. If the valve does not open, replace
switch. Contact a D
authorized service center.
WALT factory service center or a D
e
WALT synthetic or SAE
e
WALT factory service center or a D
e
WALT factory service center or a D
e
WALT factory service center or a D
e
WALT factory service center or a D
e
ENGLISH
WALT authorized
e
WALT authorized
e
WALT authorized
e
WALT authorized
e
WALT
e
15

Publicité

loading