Publicité
Les langues disponibles
Les langues disponibles
INSTALLING A GAS CYLINDER
1.
From the side of the cart, rest the 9 kg (20 lbs) (Diameter: 318 mm, Height:
475 mm) tank onto the ground. Make sure the tank valve is in OFF position.
Ensure the tank is completely upright, as it is unsafe to operate the grill if the
gas tank is not installed properly.
2. Ensure the regulator valve on the grill is completely closed by turning the
knob clockwise to the OFF position.
3.
Remove the protective caps from the regulator valve opening and the top of
the gas cylinder. Save the caps.
4. Insert the gas cylinder valve into the threaded opening of the regulator
valve. Turn the cylinder clockwise until firm. Hand-tighten only. Fig 1.
5.
Gas cylinder is now installed.
PREPARATION FOR USE – LEAK TESTING:
WARNING: NEVER USE YOUR GRILL WITHOUT LEAK TESTING ALL GAS CONNECTIONS, HOSES AND PROPANE TANK.
DANGER: TO PREVENT FIRE OR EXPLOSION HAZARD:
•
Do not smoke or permit ignition sources in the area while conducting a leak test.
•
Perform test OUTDOORS in a well ventilated area that is protected from the wind.
•
Never perform a leak test with a match or open flame.
•
Never perform a leak test while the grill is in use or while grill is still hot.
WHEN TO PERFORM A LEAK TEST:
•
After assembling your grill and before lighting for the first time, even if purchased fully assembled.
•
Every time the LP gas cylinder is refilled, exchanged or if any of the gas components are disconnected or replaced.
CHECK FOR LEAKS
CAUTION: Strong odors, colds, sinus congestion, etc. may prevent the detection of propane by smell. Use caution
and common sense when testing for leaks.
Note: The leak test must be performed in an area that is quiet, out of wind, and has adequate lighting in order to see if
bubbles are developing or so larger leaks can be detected by smell or sound.
1.
Create a mixture 50% water and 50% liquid dish washing soap.
2. Open the lid.
3.
Ensure all control knobs are set to the "OFF" position.
4. Turn on the gas at the cylinder valve. Turn the cylinder valve knob counter-clockwise to fully open. If you hear a rushing sound or
smell gas, turn the gas off. Tighten an leaking connections. If leak is detected at connection nut and tightening does not stop leak,
re-inspect propane tank rubber seal.
5.
Apply the soapy water mixture to the following:
•
Supply tank (cylinder) welds
•
Connection nut to tank valve
•
Back side of connection nut to brass nipple
•
Brass nipple connection into regulator
•
Tank valve to cylinder
•
Regulator connections to gas supply hose
6. Check each place listed for bubbles, which indicates a leak. Large leaks may not be
detected by bubbles but should produce a rushing sound or gas smell.
7.
Turn off gas supply at cylinder valve.
8
•
The full length of gas supply hose
•
Hose connection to gas manifold
•
Side burner connection to hose if appropriate
•
Side burner valve stem cap if appropriate
•
Gas supply hose connection
FIG. 1
Watch for bubbles
Publicité
