Télécharger Imprimer la page

Pit Boss 10618 Manuel Du Propriétaire page 23

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 30
Grill Produces
Grease Build-Up
Excess Or
Wood Pellet Quality
Discolored
Smoke
Fire pot Is Blocked
Insufficient Air Intake
For Fan
Frequent Flare-Ups Cooking Temperature
Grease Build-Up On
Cooking Components
PROPANE GAS GRILL
Problem
Cause
Grill will not light
The ignition wire came off
the electrical igniter/valve.
The ignition wire is broken
The battery has died
New battery doesn't work
The electrode tip does
not produce sparks at the
burner port
No gas supplied
Excessive flare-up
Grilling fatty meats
Cooking temperature
Water sprayed on gas
flames
Burner blows out
Gas tank is empty
Burner is not aligned with
the control valve
Gas supply is not sufficient
Low heat when on
Ports are blocked
"HIGH"
Gas tank has run out
Follow Care and Maintenance instructions.
Remove moist wood pellets from hopper. Follow Care and Maintenance instructions to
clean out. Replace with dry wood pellets.
Clear fire pot for moist wood pellets. Follow Hopper Priming Procedure.
Check fan. Ensure it is working properly and air intake is not blocked. Follow Care and
Maintenance instructions if dirty.
Attempt cooking at a lower temperature. Grease does have a flash point. Keep the
temperature under 176°C / 350°F when cooking highly greasy food.
Follow Care and Maintenance instructions.
SOLUTION
Reconnect the ignition wire to the electrical igniter/valve.
Contact Customer Service for assistance or a replacement part.
Install a new battery.
Check the battery polarity. The negative (-) side of the battery goes in first.
Adjust the electrode.
Check the regulator valve. Check connection for leak.
Grill fatty meats when the grids are cold, and the knobs are on the "LOW" setting.
Move the meats to the warming rack if flare-up continues.
Attempt cooking at a lower temperature. Grease does have a flash point. Keep the
temperature under 176°C / 350°F when cooking highly greasy food.
Do not spray water on gas flames.
Refill the gas tank.
Install the burner correctly.
Check the gas supply hose and make sure there are no leaks and no knots.
Clear ports of any obstructions.
Refill the gas tank.
23

Publicité

loading

Ce manuel est également adapté pour:

Navigator pb1230g10706