Horizon Hobby Hobby Zone Apprentice STOL S 700mm Manuel D'utilisation page 21

Service of Power Components
CAUTION: Always disconnect the flight battery from the model before
removing the propeller.
Disassembly
1. Remove the battery hatch.
2. Remove the 2x6mm self tapping screw (A) from the center of the spinner.
This screw secures both the propeller and the spinner.
3. Remove the three M1.6x4 machine screws (B) holding the propeller adapter
(C) to the motor, and remove the propeller adapater.
4. Remove the M2x10mm machine screw on top of the motor mount (D).
5. Remove the motor from the motor mount (E).
6. Disconnect the connectors between the motor and the ESC.
Assemble in reverse order.
Assembly Tips
• Correctly align and connect the motor wire colors with the ESC wires.
• The propeller size numbers (6 x 3.5) must face out from the motor for
correct propeller operation.
• Do not over-tighten screws. Thread the screws snugly into place, but do not
force them to turn further. Damage to plastic parts may result if you apply
too much force.
Control Horn and Servo Settings
NOTICE: Moving a linkage to another position may block the servo arm or
affect SAFE technology functionality.
The Illustration shows the factory hole settings in servo arms and control horns.
B
A
Elevator
Control Horns
Elevator
Elevator
Elevator
Ailerons
Rudder
Tail wheel
Tail wheel
Tail wheel
21
D
C
E
Servo
Use the center hole on each linear
servo arm
Apprentice STOL S 700mm
®
EN