Horizon Hobby Hobby Zone Apprentice STOL S 700mm Manuel D'utilisation page 20

EN
Smart Technology Electronic Speed Control (ESC)
This aircraft is equipped with an exclusive Smart technology electronic speed
control that can provide a variety of real-time power system related telemetry
data while you fly, including motor RPM, current, battery voltage and more to
compatible Spektrum AirWare
™
When powered on, the ESC will send the below information to the flight control
and the information will be displayed on the transmitter telemetry screen.
• RPM*
• Voltage
• Current
* During binding the transmitter will perform an auto configuration which will
populate the telemetry page. You may need to change the telemetry values on
those pages to suit this aircraft and your needs.
To enter the telemetry values:
(For iX series transmitters, you must select Save on each page)
1. Power on your transmitter.
2. Set the throttle cut to on.
3. Power on the aircraft and allow it to initialize.
4. In your transmitter, go to the Function List
(Model Setup in iX series transmitters).
5. Select the Telemetry menu option.
6. Go to the Smart ESC menu option.
7. Scroll down to Low Voltage Alarm, enter 3.4V/cell.
8. Scroll down to Poles, enter 12.
9. Return to the main screen.
Service and Repairs
NOTICE: After any impact or replacement, always ensure the receiver is
secure in the fuselage. If you replace the receiver, install the new receiver
in the same orientation and manner as the original receiver or damage may
result.
Thanks to the EPO foam material in the wing and fuselage of this aircraft,
repairs to the foam can be made using virtually any adhesive (hot glue,
regular CA (cyanoacrylate adhesive), epoxy, etc).
When parts are not repairable, see the replacement parts list for ordering by
item number. For a listing of all replacement and optional parts, refer to the list
at the back of this manual.
To access the receiver and tail servos, use a hobby knife to cut the decal along
the length of the fueselage where the top and bottom fuselage are joined. Use
clear tape to re-join the top and bottom after repair.
All the functions of this aircraft are handled in the receiver. If you need to
remove the receiver it needs to be reinstalled in the same orientation as
originally mounted. The servo connectors should be at the front of the receiver,
facing up.
Reference the diagram for servo and ESC connections.
®
equipped transmitters.
• Throttle
• FET Temperature
• BEC Temperature
DX/NX screen shots shown below
Smart ESC : Low Voltage Alarm
Smart ESC : Motor Poles
Throttle
Aileron
Elevator
Rudder
Channel 5
Channel 6
Bind/Program
20
Telemetry Alarms
3.4V
12