Panasonic PV-DV852 Manuel D'utilisation page 22

1
PUSH
AUTO MANUAL
MENU
W.B./SHUTTER/IRIS/
VOL/JOG
2
25tW
D.ZOOM
1, 3 2
OPTICAL IMAGE
STABILIZER PHOTO
SHOT
2
1
EIS
2
FADE
1, 3
1
22
Digital Zoom Function
This function is useful when you want to record close-up shots of subjects
located beyond a normal zoom range of 1k to 10k magnification. With the
digital zooming Function, you can select a magnification of 25k or 200k.
1
2
≥As the magnification of digital zooming increases, the quality of image may
deteriorate.
Cancelling the Digital Zooming Function
Set [D.ZOOM] on the [CAMERA SETUP] Sub-menu to [OFF].
≥For other notes, see page 59.
T
Optical Image Stabilizer Function
If you are recording in unstable situations and the Palmcorder is shaky, you
can use this function to correct for camera shake in these images.
≥If the Palmcorder shakes too much, this function may not be able to
stabilize images.
1
2
MEGA EIS (Optical Image Stabilizer) Function
This function increases the effect. We recommend using MEGA EIS (Optical
Image Stabilizer) Function when performing Card Photo Shot Function.
2
3
MEGA EIS
≥For other notes, see page 59.
Fade In/Out Functions
Fade In
Fade In brings out images and sounds gradually from a black screen at the
beginning of a scene.
1
2
3
Fade Out
Fade Out causes images and sounds to disappear gradually, leaving a black
screen at the end of a scene.
1
2
3
2
≥For other notes, see page 59.
Set [CAMERA FUNCTIONS] >> [CAMERA SETUP] >>
[D.ZOOM] >> [25t] or [200
≥25k: Digital zooming to 25k
≥200k: Digital zooming to 200k
To zoom in or out, press the [W/T] zoom lever towards [T] or
towards [W].
~~~~~~~~~~~~~~~~~~~~~~~~
Press the [OPTICAL IMAGE STABILIZER] Button until the
1
[EIS] Indication appears.
Press the Recording Start/Stop Button or [PHOTO SHOT]
Button to start recording.
Press the [OPTICAL IMAGE STABILIZER] Button repeatedly
until the [ EIS] Indication
MEGA
~~~~~~~~~~~~~~~~~~~~~~~~
1
Hold down the [FADE] Button while the Palmcorder is set to
the Recording Pause Mode.
≥The image fades out gradually.
When the image is completely gone, press the Recording
Start/Stop Button to start recording.
Release the [FADE] Button about 3 seconds after starting
recording.
≥The image reappears gradually.
2
Hold down the [FADE] Button while recording.
≥The image fades out gradually.
About 3 seconds after the image is completely gone, press
the recording Start/Stop Button to stop recording.
Release the [FADE] Button.
t ].
2
appears.