Panasonic PV-DV852 Manuel D'utilisation page 13

1
2
3
1
1
2
1
OPEN/EJECT
1
2
4
3 PUSH
TO CLOSE
1
R E C
SAVE
Lens Cap and Grip Belt
To protect the Lens surface, attach the Lens Cap. Adjust the length of the
Grip Belt to the size of your hand.
1
Attach the longer loop of the Lens Cap Cord to the Lens
Cap.
2
Attach the shorter loop to the grip belt.
3
Put your hand through the Grip Belt and adjust the length.
≥The removed Lens Cap can be hooked onto the grip belt
not recording, be sure to keep the Lens Cap attached to the Lens for
protection.)
~~~~~~~~~~~~~~~~~~~~~~~~~
Attaching the Shoulder Strap
We recommend that you attach the Shoulder Strap before going outdoors to
record so as to avoid dropping the Palmcorder.
1
Pass the tip of the Shoulder Strap through the Shoulder
Strap Holder on the Palmcorder and pull the Shoulder Strap.
2
Fold the tip of the Shoulder Strap, pass it through the
Shoulder Strap Length Adjuster, and pull it.
≥Pull it out more than 1 inch (2 cm)
Adjuster so that it cannot slip off.
~~~~~~~~~~~~~~~~~~~~~~~~~
Inserting a Cassette
When power is supplied to the Palmcorder, the cassette can be taken out
without turning the Palmcorder on.
1
Slide the [OPEN/EJECT] Lever to the right and pull down to
open the Cassette Compartment.
2
Insert a Cassette.
3
Close the Cassette Compartment and lock the Cassette
Compartment by pressing the [PUSH TO CLOSE] mark.
4
Close the Lower Cassette Compartment Cover.
≥For other notes, see page 59.
ª Accidental Erasure Prevention
Opening the accidental erasure prevention slider
sliding it in the [SAVE] arrow direction) prevents recording. To enable
recording, close the accidental erasure protection slider (by sliding it in the
[REC] arrow direction.)
1
. (When you are
1
from the Shoulder Strap Length
1
on the cassette (by
13