Specific Information; 2�6 Information About Electromagnetic Compatibility (Emc); 2�7 Authorized Persons - Renfert PROMIX one Mode D'emploi

► Defective equipment must be put out of service immediately. Pull out the mains plug and ensure
the equipment is not used. Send the equipment in for repair!
► Modifications to the equipment are not permitted!
en
► Only operate the equipment under supervision.
► Please observe the national accident prevention regulations!
► Information on REACH and SVHC is available on our website at www.renfert.com, in the Support
area.
2.5.2 Specific information
► Do not operate the equipment in close proximity to equipment that generates strong magnetic
fields.
► The equipment may only be used if the mains frequency information on the rating plate matches
the mains frequency of the voltage supply.
► A capsule must not be mixed several times.
► A capsule that falls out of the holder or the equipment during the mixing process must not be
used. It must be disposed of!
2.6 Information about electromagnetic compatibility (EMC)
► An interruption to the power supply that is longer than 2 seconds will interrupt the mixing process
without this being recognized or signaled.
► Electrostatic discharges can interrupt the mixing process without this being signaled.
Information about electromagnetic compatibility (EMC) can be found in a separate section at the end of
these instructions�
2.7 Authorized persons
Installation, operation, cleaning and maintenance of the equipment may only be performed by qualified,
specialist dental personnel�
Any replacement of parts and repairs not specifically described in these operating instructions may only
be carried out by the manufacturer�
2.8 Disclaimer
Renfert GmbH shall be absolved from all claims for damages or warranty if:
► The product is used for any purposes other than those specified in the operating instructions.
► The product is altered in any way other than those alterations described in the operating instruc-
tions.
► The product is not repaired by an authorized facility or if non-original Renfert parts are used.
► The product continues to be used despite obvious safety faults or damage.
► The product is subjected to mechanical impacts or is dropped.
- 4 -