Bosch Rexroth R310D4 3170 Instructions page 3

R310D4 3170 (2005.07) KBF
1. Safety, Cross-References and Symbols
1.1 Safety notes
1.2 Cross-referencing symbols
1.3 Symbols
2. Overview, Linear Bushings and Shafts
2.1 Overview, components
2.2 Expert personnel
2.3 Notes on handling Linear Bushings and Shafts
2.4 Ordering of components, catalogs and
instructions
3. Mounting Linear Bushings
in Housings
3.1 Mounting of closed Standard Linear Bushings,
Tandem, Compact and Segmental Linear
Bushings, closed Super Linear Bushings a + b
in housings
3.2 Mounting open Standard Linear Bushings
in housings
3.3 Mounting Linear Bushings for Combined Linear
and Rotary Motion in housings
3.4 Mounting open Super Linear Bushings a + b
in housings
3.5 Mounting Radial Linear Bushings in housings
3.6 Mounting Torque-Resistant Linear Bushings
in housings
3.7 Mounting Torque-Resistant Compact Linear
Bushings in housings
3.8 Mounting closed Super Linear Bushings H
in housings
3.9 Mounting open Super Linear Bushings H
in housings
3.10 Mounting closed Super Linear Bushings h
in housings
3.11 Mounting open Super Linear Bushings h
in housings
Terms
Linear Bushing
Linear Set
Shaft
Shaft Support
Block
Linear Bushing and Shaft:
6
6
6
6
8
8
15
15
15
17
17
21
25
27
31
35
39
43
45
47
51
Housing
Shaft Support Rail
Machine table
Linear Set
Linear Bushing in
housing
Shaft
Shaft Support Block
Mounting base
4. Mounting of Linear Bushing
Guideways
4.1 Mounting preparations
4.2 Basic lubrication
4.3 Parallelism offset P
4.4 Mounting Linear Bushing Guideways
with closed Linear Bushings
4.5 Mounting Linear Bushing Guideways
with open Linear Bushings
4.6 Mounting Linear Bushing Guideways
with Torque-Resistant or Torque-resistant
Compact Linear Bushings
4.7 Mounting Linear Bushing Guideways
with Torque-Resistant Linear Bushings
(with four ball guide grooves)
4.8 Mounting Linear Bushing Guideways
with Linear Bushings or with Flanged
Linear Sets
4.9 Mounting Linear Bushing Guideways
with Linear Bushings or with Tandem
Flanged Linear Sets
5. Mounting, Details
5.1 Mounting Shafts and Shaft Support Rails
to the mounting base – Details
5.2 Mounting Shafts and Shaft Support Blocks
to the mounting base – Details
5.3 Mounting Machine Tables
on Radial Compact Sets – Details
6. Adjusting Linear Sets
7. Maintenance
7.1 Checking Linear Bushing Guideways
7.2 Lubrication intervals
7.3 Lubricants
7.4 Lubricating Linear Sets with lube ports
7.5 Lubricating Linear Bushings and Linear Sets
without lube ports
F These instructions refer to the new ISO standards
wherever possible. In some cases, however, the old
standards are still used in actual practice.
3
Bosch Rexroth AG
53
53
55
61
63
67
69
71
73
77
81
81
87
93
93
95
95
95
97
97
97