Operating Suggestions - Enodis Cleveland MKDL-40-T Manuel De L'opérateur

OPERATING SUGGESTIONS

Cleveland Range Mixer Kettles are simple and safe to operate. The following tips will allow you to
maximize the use of your new mixer.
1. To achieve optimum performance on tilting kettles;
Before applying steam to a cold kettle, open the Drain Cock to drain condensate from the
kettles jacket. Close drain cock when unit is fully drained.
2. Allow unit to preheat before addition of product to kettle. However when cooking egg and milk
products, the kettle should NOT be preheated, as products of this nature adhere to hot cooking
surfaces. These types of foods should be placed in the kettle before heating is begun.
3. An important part of kettle cleaning is to prevent foods from drying on. For this reason, cleaning
should be completed immediately after cooked foods are removed. Refer to the "Care and
Cleaning" instructions for detailed kettle washing procedures.
4. If a mixer bridge is equipped with a temperature probe for a controller or thermometer, the
probe must be submerged a minimum of three inches in the product for accurate readings.
SAFETY
THIS EQUIPMENT WHEN MIXING OR LIFTING THE BRIDGE CAN EXCEED 85DB(A) AND
90DB(C), APPROPRIATE HEARING PROTECTION SHOULD BE WORN.
DO NOT LEAN ON OR PLACE OBJECTS ON KETTLE LIP. SERIOUS INJURY COULD
RESULT IF KETTLE TIPPED OVER, SPILLING HOT CONTENTS.
CLOSE TANGENT DRAW-OFF VALVE BEFORE FILLING THE KETTLE.
WHEN RAISING OR LOWERING MIXER BRIDGE, INSURE FAUCET SPOUT IS NOT IN THE
WAY OF MAIN AGITATOR ARM OR DAMAGE TO SPOUT WILL RESULT.
AS A SAFETY PRECAUTION THE MIXER SPEED CONTROL DIAL MUST FIRST BE TURNED
TO ZERO BEFORE UNIT WILL START TO MIX.
ALWAYS REMEMBER, LIKE A COOKING POT THE KETTLES BECOME VERY HOT WHEN
COOKING. AVOID CONTACT WITH BARE SKIN.