Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DIGITAL WATER METER OPERATING INSTRUCTIONS
Note: The digital counter has been preset at the factory and should operate satisfactory. If
installing a new counter (or the configuration settings to your existing digital counter become
corrupted) you must configure the digital counter as shown below (Configuring a Digital Counter)
prior to operation.
1. Turn POWER switch "ON".
2. Set required volume by first pushing the
key until the digit you want to change is flashing in
the lower display. Then use the
key to change the value of the selected digit.
When all digits are set, press the ENT key.
3. Locate delivery spout over desired kettle.
4. Turn START switch to "RESET". Delivery will start at "0" and stop at preset volume.
5. To stop delivery at any time, turn INTERRUPT switch.
6. To complete delivery after interrupting, turn START switch to "CONTINUE".
7. Turn POWER switch to "OFF" when meter is not in use.
Publicité
Table des Matières
