Connecting The Printer - WEPA TOPITEC AUTOMATIC Mode D'emploi

6.2 Interfaces of TOPITEC
For the documentation of your preparations and production runs, we recommend connecting
a SARTORIUS data printer (model YDP20-0CE) to your TOPITEC
1.
3.
4.
AUTOMATIC
®
1. First check whether the printer is correctly configured for
connection and printing. The baud rate must be set to 9600.
For detailed instructions, please refer to the user manual
of the printer.

2. Connecting the printer

Connect the printer power cable to the socket. The printer is
automatically switched on. The display shows the time and the
activated numerator (NUM). Deactivate the numerator by press-
ing the [N/N] button.
3. The serial port for PC connection (RS 232) is located at the rear
of the TOPITEC AUTOMATIC.
®
Connect the serial cable (prod. no. 25 025663) to the serial port
at the rear of the printer (labelled DATA).
4. The printer cable can be connected.
Ensure that all adapters are properly inserted in the ports. The
printer can be connected before the TOPITEC
started or during production.
® AUTOMATIC
AUTOMATIC is
®
31