Shut-Down Procedure - WEPA TOPITEC AUTOMATIC Mode D'emploi

4.5 Shut-down procedure

Danger
Prior to any cleaning, maintenance or repair tasks
(to be performed by an electrician), shut down the device as described
below:
1. Lower the slide to its initial position and remove the jar.
2. Disconnect the TOPITEC
• Set the main switch (power switch) to position "0".
• Secure the TOPITEC
by disconnecting the power cable from the socket.
2.1 For maintenance and repair work only:
• Check the device to ensure that it is fully de-energized.
• Cover or otherwise insulate adjacent parts that remain powered.
Danger
Non-compliance can result in serious or even fatal injury
(from accidental voltage transfer)!
Capacitors might retain some dangerous residual voltage.
Before commencing work, check the capacitors and de-energize them slowly.
If a task cannot be performed when the device is shut down as described
above, contact your dealer or carry out the task with due regard to the
internal risk assessment.
AUTOMATIC from the power supply:
®
AUTOMATIC against inadvertent restart
®
25