WEPA TOPITEC AUTOMATIC Mode D'emploi page 102

TO P I T EC
Setup for once-off preparation
M: to 200g
Press 1 x Set : "M: to 200 g" flashes
Set
Press 1 x Set : "Min" flashes
Set
+/–
Set with "Min"
+/–
Press 1 x Set : "rpm" flashes
Set
Set "rpm" with +/–
+/–
Press Set 1x to confirm entry
Set
Press 1 x I/0 I/0 to start the process
Slide moves up & tool shaft engages.
Programme starts ("rpm" flashes and could
be changed if necessary by pressing
Program time countdown begins.
"Program terminated"
"Release tool shaft"
"Move slide"
Lift safety bracket and keep it in the upwards posi-
tion, release tool shaft from shaft retainer, pressing
the button down until the slide has moved
downwards with the jar clamped in place.
Automatic: Default settings
Button functions
+/– Set values for "min.", "rpm"; select mode, or "Prep. no."
– Press 1x "Manual slide movement" to move slide
based on default settings (M: to 200 g, 0:00 min., 000 rpm)
Set
Select menu option (mode/min./rpm/pause/prep. no.) and confirm
Actuate when prompted by system: "Release tool shaft" and"Move slide".
Do not forget to release the tool shaft! Lift the safety bracket!
I/0 When the container is engaged, the next cycle is started.
Alternatively, the process is terminated prematurely. Next the stirring programme
is continued following a safety bracket interruption.
Stop Only press this button if there is an error or malfunction! (After switching off the
TOPITEC AUTOMATIC system it must be restarted, see TOPITEC
®
"Troubleshooting"). Exception: Change from save mode to default mode.
36
TOPITEC ® AUTOMATIC User Manual | 12-2020
AUTO MAT IC Q UICK S TA RT
®
).
+/–
+/–
Mixing container clamped in slide Default settings:
M: to 200 g, 0:00 min. , 000 rpm
Single-step preparation
Set
Set
Press
I/0 I/0
Press
Slide moves up & tool shaft engages.
Program time countdown begins.
"Program terminated"
"Release tool shaft"
"Move slide"
Lift safety bracket and keep it in the upwards posi-
manual, section
®
tion, release tool shaft from shaft retainer, pressing
the
downwards with the jar clamped in place.
Stop
Press Stop
Initial position:
1x: "Prep. no." (e.g. 1/1) flashes
1x to start process
button down until the slide has moved
1x: Default settings