R E P R O D U Cible Pr E Par Ation Set- Up - WEPA TOPITEC AUTOMATIC Mode D'emploi

M I X I N G M OD E / M I X I N G M OD E /

R E P R O D U CIBLE PR E PAR ATION SET- UP

R E P R O D U CIBLE PR E PAR ATION SET- UP
Setting up single-step preparations
1.
2.
3.
4.
5.
6.
7. All entered values are saved under the respective prep. no. (here: 1). In future you only need to
call up the "Prep. no. 1" and production can start. To start production, press the
Alternatively, you can set other preparations in the system or press
TOPITEC ® AUTOMATIC default settings.
42
TOPITEC ® AUTOMATIC User Manual | 12-2020
1. If you wish to produce the same preparation more than once, you can
save the respective system settings in one of the 99 available memory
slots so that they can later be called up at the push of a button. After
switching on the system, the default settings are displayed.
2. To call up a memory slot, press
"prep. no" flashes on the display.
3. Press :
Set
"M: to 200g" (mode display) flashes. Press
"M: to 200g" is continuously shown. "min." flashes.
4. Using the button, enter the desired time in minutes and
+
seconds. If you have inadvertently selected a value that is too
high, press the button to correct it. Press
–
You can now adjust the speed.
5. Using the
button, enter the desired speed.
+
6. Now press the button 3x. The preparation number is shown on
Set
the display:
(here: 1x).
+
again:
Set
1x.
Set
button.
I/0
to return to the
Stop