WEPA TOPITEC AUTOMATIC Mode D'emploi page 101

M O D E OP T IO N S / BUT TO N FUN CTI O N S
• M: to 200 g
• M: from 300 g
• Comminution
• Powder mixing
Mode selection for once-off production of
single preparation
Set Set
Press 1 x : "M: to 200 g" flashes
Select with +/- "Mode"
+/–
Press 1 x Set : "Min" flashes
Set
Set with "Min"
+/– +/–
Press 1 x : "rpm" flashes
Set Set
Set "rpm" with
+/–
+/–
Press Set 1x to confirm entry
Set
I/0
Press 1 x I/0 to start the process
Slide moves up & tool shaft engages.
Programme is started ("rpm" flashes; if necessary,
+/–
adjust rpm by pressing ).
+/–
Program time countdown begins.
"Program terminated"
"Release tool shaft"
"Move slide"
Lift the safety bracket and keep it upwards, unlock
tool shaft from the shaft retainer, pressing the
button until the slide has moved downwards
with the jar clamped in place.
Automatic: Default settings
Button functions
+/–
Set values for "min.", "rpm"; select mode, or "Prep. no."
–
Press 1x "Manual slide movement" to move slide
based on default settings (M: to 200 g, 0:00 min., 000 rpm)
Set
Select menu option (mode/min./rpm/pause/prep. no.) and confirm
Actuate when prompted by system: "Release tool shaft" and
"Move slide". Do not forget to release the tool shaft!
Lift the safety bracket!
I/0
When the container is engaged, the next cycle is started.
Alternatively, the process is terminated prematurely. Next the stirring programme
is continued following a safety bracket interruption.
Stop
Only press this button if there is an error or malfunction! (After switching off
the TOPITEC AUTOMATIC systemit must be restarted, see TOPITEC
®
section "Troubleshooting") Exception: Change from save mode to default mode.
manual,
®
35