WEPA TOPITEC AUTOMATIC Mode D'emploi page 126

1 0 PR AC T ICAL T IPS – INS TAN T RE M EDY!
When the STOP button is pressed,
message "Stop: program abort" is displayed on the display.
Press the button and switch off the TOPITEC
Stop
at the power switch. Eliminate the cause of the problem.
Switch on the system.
The display shows two alternating messages: "Release tool shaft" and "Move slide".
After having released the shaft locked and moved the slide by hand, the TOPITEC
is again in its initial position and ready for operation. The display shows the default settings
(M: to 200 g; 0:00 Min; 000 rpm).
Select the desired mode (mixing, grinding, powder-mixing)
Or select the required "Prep. No." using the
You can now continue working with the TOPITEC
Locking device is released during production
Repeat opening and closing of the two locking handles of the clamping device might lead to a
reduction of the clamping force. In this case, the locking device might begin to move up during
production.
60
TOPITEC ® AUTOMATIC User Manual | 12-2020
AUTOMATIC
®
or button.
+ –
AUTOMATIC system.
®
AUTOMATIC
®