Recalling The Home Position; Enabling The Wiper (Wiper); Enabling The Washer (Washer); Reboot The Device - Videotec ULISSE PLUS Manuel D'instructions

11.6 Recalling the Home
position
Using the control device it is possible to recall the
Home position (Scan No. 1) (for further information
refer to the manual of the control device in use).

11.7 Enabling the Wiper (Wiper)

h Do not use the wiper when the outside
temperature is below 0°C or in case of ice.
To enable/disable the Wiper refer to the manual of
the control device in use or to Tab. 13, page 46).
If it is left on, the Wiper automatically
j
disables itself.
11.8 Enabling the Washer
(Washer)
h Do not use the wiper when the outside
temperature is below 0°C or in case of ice.
Before using the washing system save a Preset with
the housing glass positioned in correspondence with
the spray.
To enable/disable the Washer refer to the manual of
the control device in use or to Tab. 13, page 46).
Wash duration can be set using in the OSM menu
("9.6.8.2 Washer Menu", page 36).

11.9 Reboot the device

By means of the control device it is possible to
send the device resetting command (for further
information refer to the manual of the control device
in use or to Tab. 13, page 46).
45