Identification; Product Description And Type Designation; Product Marking; Preparing The Product For Use - Videotec NXM Manuel D'instructions

4 Identification

4.1 Product description and type
designation
The NXM housing, entirely constructed from AISI
316L electropolished stainless steel, is designed
to operate in specialist environments such as
marine, industrial, chemical and where the external
conditions are highly corrosive.
In order to prevent the formation of dust deposits,
the housing can be equipped with a flange designed
to create an air barrier in front of the glass.
The air, normally drawn from a compressor, can be
purified by the optional filter group.
The options of wiper and water pump ensure a
constant cleaning of the front window
The NXM housing can be installed on NXPTH Pan &
Tilt head, to obtain a complete positioning system.

4.2 Product marking

See the label attached to the product.
5 Preparing the product for
use
Any change that is not expressly approved
by the manufacturer will invalidate the
guarantee.

5.1 Unpacking

When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
When returning a faulty product we recommend
using the original packaging for shipping.
Keep the packaging in case you need to send the
product for repairs.
MNVCNXM_1718_EN
5.2 Contents
Check the contents to make sure they correspond
with the list of materials as below:
• Housing
• Housing equipment:
• Allen wrench
• Spacers
• Bolts and screws
• Instruction manual
5.3 Safely disposing of packaging
material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.

6 Installation

6.1 How to open the housing

Unscrew the bolts on the rear flange, using the allen
wrench supplied.
Fig. 1
Slide out the rear cover plate of the housing, taking
care to leave the sealing washer in its seating.
Fig. 2
5