About This Manual; Typographical Conventions; Notes On Copyright And Information On Trademarks; Safety Rules - Videotec MEDUSA Mode D'emploi

1 About this manual
Before installing and using this unit, please read this
manual carefully. Be sure to keep it handy for later
reference.

1.1 Typographical conventions

DANGER!
g g
High level hazard.
Risk of electric shock; disconnect the
power supply before proceeding with any
operation, unless indicated otherwise.
WARNING!
h g
Medium level hazard.
This operation is very important for the
system to function properly. Please read
the procedure described very carefully and
carry it out as instructed.
INFO
j g
Description of system specifications.
We recommend reading this part carefully
in order to understand the subsequent
stages.
2 Notes on copyright and
information on trademarks
The quoted names of products or companies are
trademarks or registered trademarks.
3 Safety rules
The manufacturer declines all responsibility
h g
for any damage caused by an improper use
of the appliances mentioned in this manual.
Furthermore, the manufacturer reserves
the right to modify its contents without any
prior notice. The documentation contained
in this manual has been collected with great
care, the manufacturer, however, cannot
take any liability for its use. The same thing
can be said for any person or company
involved in the creation and production of
this manual.
• The device must be installed only and exclusively
by qualified technical personnel.
• Before any technical work on the appliance,
disconnect the power supply.
• Do not use power supply cables that seem worn
or old.
• Never, under any circumstances, make any
changes or connections that are not shown in
this handbook: improper use of the appliance
can cause serious hazards, risking the safety of
personnel and of the installation.
• Use only original spare parts. Not original spare
parts could cause fire, electrical discharge or other
hazards.
• Before proceeding with installation check the
supplied material to make sure it corresponds
to the order specification by examining the
identification labels ("4.2 Product markings", page 4).
• This device was designed to be permanently
installed on a building or on a suitable structure.
• When installing the device, comply with all the
national standards.
• The electrical system of the building on which
the device is to be installed must have a two-pole
protection circuit (circuit breaker) complete with
an automatic two-pole switch which provides
protection for earth fault current (circuit breaker
+ differential) with a minimum distance between
contacts of 3 mm.
• Any device which could be installed inside the
housing must comply with the current standards.
4 Identification
4.1 Product description and type
designation
Housing for discreet surveillance that can be used in
both indoor and outdoor installations. It is designed
to be camouflaged with normal lighting systems.
Easy to install, this model is able to house a range of
speed domes. The housing is mounted with internal
cable management bracket; the bracket can be for
wall, ceiling or parapet mount.
This installation kit allows installation of SONY
cameras inside the MEDUSA.
3