Product Markings; Preparing The Product For Use; Safety Precautions Before Use; Contents And Unpacking - Videotec MEDUSA Mode D'emploi

4.2 Product markings

See the label attached to the outside of the package.
5 Preparing the product
for use
Any change that is not expressly approved
h g
by the manufacturer will invalidate the
guarantee.
5.1 Safety precautions before
use
In the 115/230Vac powered configuration
g g
it is necessary to insert a 1 0 unipolar
main switch (open contact distance
d>3mm) upstream on the power line. This
switch should be used to disconnect the
power supply before carrying out any
maintenance operation or before opening
the housing.

5.2 Contents and unpacking

When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
Keep the packaging in case you need to send the
product for repairs.
Check the contents to make sure they correspond
with the list of materials as below:
Housing packing
• MEDUSA housing
• Housing equipment:
• Cable glands with nuts
• Plate for cable glands
• Gasket for plate
• Screws for plate
• Allen wrench
• Desiccant salt bag
Adapter packing
• Adapter
• Adapter equipment:
• Earthed cables
• Screws for fastening the camera
• Instructions manual
4
5.3 Safely disposing of
packaging material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
Bear in mind that if the material has to be returned
due to a fault, using the original packaging for its
transport is strongly recommended.
6 Installing and
assembling
Only specialised personnel should be
h g
allowed to install and assemble the device.

6.1 Assembly

6.1.1 Assembling the camera

In case of a 24Vac adapter, fasten the
h g
camera directly to the plate by means of
four M3x10mm screws and the washers
Temporarily loosen the two connectors linked to the
WR transformer.
Fig. 01
Dismantle the WR transformer board from the
adapter, loosening the 4 screws, to allow the
assembling of the camera.
Fig. 02