Identification; Product Description And Type Designation; Product Markings; Preparing The Product For Use - Videotec HOV Hi-PoE IPM Manuel D'instructions

Masquer les pouces Voir aussi pour HOV Hi-PoE IPM:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

• If the installation is NEMA TYPE 4X, the installer
must replace the cable glands of the product with
NEMA TYPE 4X cable glands.
• For all connections, use cables that are able to
withstand temperatures of at least 75°C (167°F).
• The product is designed to house only cameras
that are properly certified.

4 Identification

4.1 Product description and type
designation
The HOV Hi-PoE IPM housing exploits in an optimal
way the POE and Hi-POE technology, using the power
supplied by the Ethernet cable as the sole source of
power for all the devices connected, thus ensuring
the maximum efficiency and flexibility of the
network system as well as user-friendly installation
and low costs.
The innovative IPM (Intelligent Power Management)
system enables extremely quick and easy installation
with the use of a single Ethernet connecting cable.
The Hi-POE IPM system automatically detects all
the options, like heating, fan and illuminator and
then autonomously balances the power to ensure
suitable distribution of the same to the connected
devices. This guarantees the optimal operation of the
IP camera between -30°C (-22°F) and +60°C (140°F),
with heat regulation and cold start (activation at low
temperature).
The analog system, with previously installed camera
housings, can be retrofitted on IPM system simply
by changing the slide and the internal electronics.
This enables the digital conversion, speeding up
the installation and thereby minimizing costs and
environmental impact.
Very easy to install thanks to the side opening system
that allows the full access to the camera, lenses and
all internal connections.

4.2 Product markings

See the label attached to the product.
4
5 Preparing the product for
use
Any change that is not expressly approved
by the manufacturer will invalidate the
guarantee.

5.1 Unpacking and contents

5.1.1 Unpacking

When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
Keep the packaging in case you need to send the
product for repairs.
5.1.2 Contents
Check the contents to make sure they correspond
with the list of materials as below:
• Housing
• RJ45 wiring
• Housing equipment:
• Allen wrench
• Spacers
• Cable glands gaskets
• Cable glands (x3)
• Bolts and screws
• Screws for camera
• Instructions manual
• Desiccant bag
5.2 Safely disposing of packaging
material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
When returning a faulty product we recommend
using the original packaging for shipping.

Publicité

Table des Matières
loading

Table des Matières