Assembling The Plate With The Cable Glands; Installation; Installing The Housing - Videotec MEDUSA Mode D'emploi

6.1.2 Assembling the plate with the
cable glands
This section describes how to assemble the plate with
cable glands that is supplied with the housing.
Attach the cable glands facing the direction shown,
taking care to tighten the nuts properly.
Fig. 07
Attach the gasket by inserting the screws into the
holes in the plate and then into the holes in the
gasket.
Fig. 08
If you are using a self-adhesive gasket
h g
attach it to the plate in the same position.
The plate is now ready for installation in the housing
6

6.2 Installation

6.2.1 Installing the housing

This operation must be carried out with the
g g
power supply disconnected.
Attach the bracket firmly at the chosen spot. Remove
the housing cover by undoing the 4 screws on the
top and leave it hanging from the anchorage cable.
Fig. 09
Insert the housing body into the coupling seat
provided and fasten it down immediately using the
two screws supplied with the support.
Fig. 10
Pass the various wires and cables through the bracket
into the inside of the housing; these cables should be
locked by the cable glands on the plate supplied with
the housing. Then close the plate using the 4 self-
tapping triangular M3 slotted screws supplied.
Fig. 11