Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5 Preparing the product
for use
Any change that is not expressly approved
h
h
by the manufacturer will invalidate the
guarantee.
5.1 Contents and unpacking
When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
Keep the packaging in case you need to send the
product for repairs.
Check the contents to make sure they correspond
with the list of materials as below:
• Upper bracket
• Lower bracket
• Covered steel cables
• Snap hook
• Eye-bolt
• Hook bolt
• Chain
• Sunshield
• Brackets for sunshield
• Equipment
• Instructions manual
5.2 Safely disposing of
packaging material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
Bear in mind that if the material has to be returned
due to a fault, using the original packaging for its
transport is strongly recommended.
2
6 Assembling and
installing
Only specialised personnel should be
h
h
allowed to assemble and install the device.
6.1 Installation
6.1.1 Brackets and pan & tilt
installation
h
h
If the appliance must be fixed to a concrete
surface, plugs must be used with minimum
tractive force of 300 daN each. If the
surface is in metal, use screws with a
minimum diameter equal to 8mm and with
appropriate length.
Fix the upper bracket to the ceiling, centring it with
respect to the cable that must escape from the ceiling
by 1m.
Fig. 01
Fix the base of ULISSE COMPACT onto the lower
bracket adding Loctite 238 or equivalent.
j
h
Respect the orientation
visible in figure.
Fig. 02
Publicité
Table des Matières
