Preparing The Product For Use; Unpacking; Safely Disposing Of Packaging Material; Installation - Videotec EXH Manuel D'instructions

5 Preparing the product for
use
Before carrying out any type of
intervention, read the "Safety rules"
chapter of this manual.

5.1 Unpacking

When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
When returning a faulty product we recommend
using the original packaging for shipping.
Keep the packaging in case you need to send the
product for repairs.
5.2 Contents
Check the contents to make sure they correspond
with the list of materials as below:
• Flameproof housing
• O-ring replacement part kit
• Spacers for camera
• Instruction manual
5.3 Safely disposing of packaging
material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
12

6 Installation

Before carrying out any type of
intervention, read the "Safety rules"
chapter of this manual.

6.1 Installation options

The product cannot be installed upside
down.
Fig. 3

6.2 Sunshield mounting

Available as an accessory.
You can fix the sunshield to the housing using the
screws supplied.
Remove the protective film before the
sunshield installation (if present).
Apply a generous amount of thread locking
compound (Loctite 270) into the threaded holes in
the base of the device.
The thread compound must cure for one hour, allow
for this period prior to completing the installation.
Fig. 4
MNVCEXH_2104_EN