Preparing The Product For Use; Unpacking; Safely Disposing Of Packaging Material; Preparatory Work Before Installation - Videotec HOV Manuel D'instructions

5 Preparing the product for
use
Any change that is not expressly approved
by the manufacturer will invalidate the
warranty.

5.1 Unpacking

When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
When returning a faulty product we recommend
using the original packaging for shipping.
Keep the packaging in case you need to send the
product for repairs.
5.2 Contents
Check the contents to make sure they correspond
with the list of materials as below:
• Housing
• Housing equipment:
• Allen wrench
• Spacers
• Cable glands gaskets
• Cable glands (x3)
• Bolts and screws
• Instruction manual
• Desiccant bag
6
5.3 Safely disposing of packaging
material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
5.4 Preparatory work before

installation

5.4.1 Mounting the bracket

The product must be fastened with
suitable equipment. The fastening means
must guarantee mechanical sealing when
a force equal to at least 4 times the weight
of the device is applied.
6 Installation

6.1 Housing opening

Loosen the 2 screws on the side, turn the cover and
the upper half of the body about the opening hinge
axis.
Fig. 1
After installation and wiring, close the
product.
MNVCHOV32_2222_EN