How To Install The Camera; Board Description - Videotec HOV Manuel D'instructions

6.2 How to install the camera

Power supply can be provided by the
board supplied with the product. Make
sure the voltage values are appropriate.
Open the housing as described in the relative
chapter (6.1 Housing opening, page 6).
Partially loosening the fastening screws (01).
Remove the internal slide (02) by sliding it until the
holes coincide with the slide fastening screws.
Fasten the camera with the 1/4" screw (03). To
position the camera and lens correctly, if necessary,
use the supplied spacers. (04).
03
01
03
Fig. 2
Reposition the internal slide and tighten the screws
that had been loosened previously.
Remove the conductors protective sheathing and
connect them to terminal (J5, 6.3 Board description,
page 7).
The camera's power supply cable conductors must
be tied up with a cable tie next to the terminal. Keep
the signalling and power supply cables separated
from each other.
MNVCHOV32_2222_EN

6.3 Board description

BOARD DESCRIPTION
Connec-
tor
J1
J2
J3
J4
02
J5
J7
J8
SW1
Tab. 1
Fig. 3
The board may appear different to that
illustrated.
Depending on the product version, the
board may not be equipped with all
functions.
Function
Power supply for
the board (V )
IN
Auxiliary output
(V )
OUT
Heater power
supply
Tamper switch
contacts
Camera power
supply (V )
OUT
Power supply conn
ector/jumper
Fan power supply
Tamper switch
J8
SW1 J7
Nominal section of the cables used: from
0.2mm² (24AWG) up to 2.5mm² (13AWG).
Notes
Same voltage applied on J1
Only some models
Depending on the power sup-
ply model the two connectors
have different use.
If powered in 12vdc connector
A corresponds to polarity +,
while connector B corresponds
to polarity - .
If powered in 24vac connectors
A and B are equivalent and
correspond to the voltage Vac.
Jumper present only in ventila-
ted models
Only some models
J2 J1 J4
J3 J5
7