Installation Of The Version With Wiper; Desiccant Bag; Accessories; Heater - Videotec HOV Manuel D'instructions

6.6 Installation of the version
with wiper
Open the housing as described in the relative
chapter (6.1 Housing opening, page 6).
Identify the terminal of the wiper board.
Fig. 7
Connect the wiper board to the power supply mains
as shown in the figure.
L
~
N
Fig. 8
Nominal section of the cables used: from
0.2mm² (24AWG) up to 2.5mm² (13AWG).
Pressing the button activates the wiper. When the
button is released the wiper blade will return to the
rest position.
If you have a receiver with the Wiper control
function, connect the SW, PER and COM terminals
respectively to terminals S, P and C of the board.

6.7 Desiccant bag

Take the dessicant salt bag out of its pack and insert
it into the product.
MNVCHOV32_2222_EN
P
S
C
P
S
C

7 Accessories

For further details on configuration and
use, refer to the relative manual.

7.1 Heater

7.1.1 Heater installation

Open the housing as described in the relative
chapter (6.1 Housing opening, page 6).
Fix the heater kit to the prearranged points on the
body of the housing.
The pre-wired heating element (01) should be
positioned between the 2 dissipators (02) before
attachment to ensure contact and hence guarantee
correct heat transmission.
Pass the heating wiring under the slide to fix the
camera.
01
Fig. 9
At the end of istallation, connect the wiring to
the terminal (power supply connector, 6.3 Board
description, page 7).
Reposition the internal slide and tighten the screws
that had been loosened previously.
02
02
9