Instructions For Normal Operation; Visualizing The State Of The Pan & Tilt; Saving The Current Position (Preset); Recalling A Position (Scan) - Videotec ULISSE PLUS Manuel D'instructions

11 Instructions for normal
operation
11.1 Visualizing the state of the
pan & tilt
During normal operation the pan & tilt displays
on screen the data organized as illustrated (user's
choice). Visualization can be enabled or disabled as
described in "9.6.7 Display menu", page 34.
ID 1: Receiver's address;
ZONE 1: Name of the area where one is currently
located;
MASK 1: Name of the mask where one is currently
located
ALARM 1: Text regarding the last active alarm;
Preset 001 go to: Commands received via serial;
E1 PATROL CONFIGURATION: The following field
shows the errors found while the system was running;
PAN/TILT/Z/F/I: Current position of PAN, TILT, ZOOM,
FOCUS and IRIS;
PRESET 001: Name of selected active preset.
ID 1
ZONE 1
MASK 1
ALARM1
Preset 001 go to
E1:PATROL CONFIGURATION
PAN : +000.00
TILT: +000.00
Z:000.0 F:000.0 I:000.0
PRESET 001
Fig. 105
44
11.2 Saving the current position
(Preset)
The current position can be saved using the control
device being used (for additional information refer to
the manual of the device being used).

11.3 Recalling a position (Scan)

Using the control device it is possible to recall
a previously saved Preset position (for further
information refer to the manual of the control device
in use).

11.4 Enabling Patrol function

The Patrol function loads the saved Presets in
sequence.
Using the control device it is possible to enable the
automatic patrol (for further information refer to
the manual of the control device in use or to Tab. 13,
page 46).
Disabling can be carried out by moving the joystick
or by recalling a different type of movement.

11.5 Enabling Autopan Function

The Autopan function loads the 2 saved Presets in a
continuous manner.
Using the control device it is possible to enable the
Autopan (for further information refer to the manual
of the control device in use or to Tab. 13, page 46.
Disabling can be carried out by moving the joystick
or by recalling a different type of movement.