Maintaining And Cleaning; Maintaining; Replacing The Fuses; Cleaning - Videotec ULISSE PLUS Manuel D'instructions

Unité de positionnement de grandes dimensions
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

12 Maintaining and cleaning

12.1 Maintaining

12.1.1 Replacing the fuses

g
Always make the base connections with the
power supply disconnected and the circuit-
breaker open.
There are 2 fuses on the connector board.
F2
Fig. 106
Their sizes are related to the power supply voltage, as
shown in the table.
VOLTAGE
FUSE F1
24Vac 50/60Hz
T 4A L 250V 5x20
120Vac 50/60Hz
T 4A L 250V 5x20
230Vac 50/60Hz
T 4A L 250V 5x20
Tab. 15
F1
FUSE F2
T 6.3A H 250V
5x20
T 4A H 250V 5x20
T 2A H 250V 5x20

12.2 Cleaning

The pan & tilt devices require no particular
maintenance. To clean the device use neutral
detergent and a non-abrasive cloth. Remember that
the device is waterproof.
12.2.1 Window and plastic cover
cleaning (PC)
Surface dirt should be rinsed away with water and
then the window cleaned with a neutral soap diluted
with water, or specific products for spectacle lens
cleaning. These should be applied with a soft cloth.
h
Avoid ethyl alcohol, solvents, hydrogenated
hydrocarbide, strong acid and alkali. Such
products may irreparably damage the
surface.
13 Disposal of waste
materials
This symbol mark and recycle system
n
are applied only to EU countries and not
applied to the countries in the other area of
the world.
Your product is designed and manufactured with
high quality materials and components which can be
recycled and reused.
This symbol means that electrical and electronic
equipment, at their end-of-life, should be disposed of
separately from your household waste.
Please dispose of this equipment at your local
Community waste collection or Recycling centre.
In the European Union there are separate collection
systems for used electrical and electronic products.
47

Publicité

Table des Matières
loading

Table des Matières