Operating Status; Closing The Housing; Cleaning; Window And Plastic Cover Cleaning - Videotec PUNTO HI-POE Manuel D'instructions

8.2 Operating status

The LEDs shown in the figure allow to check the
product's operating status.
LD1
Fig. 13
Refer to the table to identify the operating status.
OPERATING STATUS
LED LED Status Apparatus Status
LD1 (Ca- Off
mera)
On
1 flashing
2 flashings
5 flashings
9 flashings
LD2 (Power Off
supply)
On
LD3 (He- Off
ater)
On
Tab. 2

8.3 Closing the housing

Take the dessicant salt bag out of its pack and insert
it into the product. At the end of the installation close
the housing.
8
LD3
LD2
The camera is not connected
The camera is correctly
powered
The camera has a low identifica-
tion resistance
The camera has a high identifi-
cation resistance
The camera has an excessive
energy consumption
The camera requires more
energy than the available
The device is not powered
The device is correctly powered
Heating is inactive
Heating is active

9 Cleaning

9.1 Window and plastic cover
cleaning
Avoid ethyl alcohol, solvents, hydrogenated
hydrocarbide, strong acid and alkali. Such
products may irreparably damage the
surface.
We recommend using a soft cloth with neutral soaps
diluted with water or specific products to clean the
glasses lenses.
10 Disposal of waste
materials
This symbol mark and recycle system
are applied only to EU countries and not
applied to the countries in the other area of
the world.
Your product is designed and manufactured with
high quality materials and components which can be
recycled and reused.
This symbol means that electrical and electronic
equipment, at their end-of-life, should be disposed of
separately from your household waste.
Please dispose of this equipment at your local
Community waste collection or Recycling centre.
In the European Union there are separate collection
systems for used electrical and electronic products.
MNVCHEEPOE_2104_EN