9.6.6.5 Preset Menu (Preset Utilities)
Once inside the Utilities Configuration menu it is
possible to set the following parameters:
01. Scan Speed: This is the reference speed used
when a preset position is recalled by the Scan
function.
02. Default Speed: Changes the default speed
of the Presets. This value is used based on the
function Set Speed? to assign the same speed
to all Presets .
03. Default Dwell time: Changes the default pause
of the Presets. This value is used based on the
function Set Dwell Time? to assign all Presets
the same pause time.
04. Ramp Value: The Ramp parameter is used
to change start and stop times. The higher
the number, the greater the acceleration/
deceleration during starting/stopping.
05. Set Speed?: To assign all Presets the same
default speed.
06. Set Dwell Time?: To assign all Presets the same
default dwell time.
PRESET UTILITIES
------------------------
1>SCAN SPEED
2 DEFAULT SPEED
3 DEFAULT DWELL
4 RAMP VALUE
5 SET SPEED?
6 SET DWELL TIME?
Fig. 71
: 20.00
: 10.00
:
3
:
12
9.6.6.6 Patrol Menu
01. First Preset: Sets the first preset of the Patrol
sequence.
02. Last Preset: Sets the last preset of the Patrol
sequence.
03. Random Mode: Enables random execution. The
sequence is re-calculated on a continuous basis.
PATROL
------------------------
1>FIRST PRESET
2 LAST PRESET
3 RANDOM MODE
Fig. 72
9.6.6.7 Autopan Menu
01. Preset Outward Movement: Sets the initial
position of the Autopan.
02. Preset Return Movement: Sets the final
position of the Autopan.
AUTOPAN
------------------------
1>PRESET OUTWARD:
2 PRESET RETURN :
Fig. 73
j
The movement speed is specified inside the
Preset ("9.6.6.4 Preset Menu (Edit Preset)",
page 32).
:
1
: 250
:
N
1
2
33