Patient Preparation; Operating Instructions - I-Tech MIO-CARE TENS Notice D'utilisation

Should any foreign materials penetrate the device contact the retailer or
manufacturer immediately. If dropped down, check that the housing is
not cracked or damaged in any way; if so, contact the retailer or
manufacturer.
Should you notice any changes in the device's performance during
treatment, interrupt the treatment immediately and consult the retailer
or manufacturer.
If the stimulation is uncomfortable decrease intensity. If the problem
persists consult a doctor.
Some patients could suffer from skin irritation or oversensitivity due to
stimulation or gel. If the problem persists, suspend the stimulation and
consult a doctor.
Consult a doctor before using MIO-CARE with metallic osteosynthesis devices. IF
YOU HAVE ANY DOUBTS REGARDING THE DEVICE USE CONSULT YOUR DOCTOR.

Patient preparation

Before using MIO-CARE clean the skin of the area to be treated; with the cable
disconnected from MIO-CARE, connect the electrostimulation cable jacks to the
self-adhesive electrodes; position the self-adhesive electrodes on the skin (see
photos of electrode positions in the Positions manual); connect the impulse
transmission cables to the relative jacks (Channel 1 and/or Channel 2), then turn
MIO-CARE on.
Splitting leads use: please use splitting leads if you want to double electrodes
number for each channel. Connect the splitting cable jacks to the self-adhesive
electrodes, with the cable disconnected from MIO-CARE; position the self-
adhesive electrodes on the skin (see photos of electrode positions in the
Positions manual); connect the splitting leads cables to the impulse transmission
cables that are connected to the relative jacks (Channel 1 and/or Channel 2),
then turn MIO-CARE on.
Make sure that MIO-CARE is switched off before disconnecting the
electrodes at the end of the treatment.
Device use

Operating instructions

It is recommended reading the entire user manual before using.
1. Turn MIO-CARE on using the ON/OFF button.
2. The display shows the number of the programs on the upper side, the
selected program number on the middle-left side and on the right the
program time:
IACER Srl 75 MNPG95-05